Use and maintenance of inflatable tents

Jun 10, 2024

Leave a message

The black valve is a quick inflation port, the gray valve is a multi-function valve (manual decompression, exhaust, and air replenishment), and the white valve is a high-pressure explosion-proof valve, also known as a pressure reducing valve.

Black valve: used to quickly inflate the tent. After the inflation is completed, please note that the black valve cover should not be twisted hard. If you twist it hard for a long time, it will leak. Just make sure it is twisted tightly without leaking.

Gray valve: used for air replenishment. If the pressure of the air column is small, you can use the gray air valve. When folding the tent, use the gray valve to exhaust air.

White pressure reducing valve: In summer, open the black lid of the inflatable tent to avoid excessive pressure. In summer, the sun shines directly inside. The air pressure will rise, and the pressure reducing valve will automatically discharge the pressure when it exceeds the set pressure of the tent.

Precautions for tent air column
Try not to pull it hard after opening it. Uneven ground or sharp stones dragging it back and forth will reduce the service life of the tent. Prevent sharp objects from piercing or scratching the air column, such as (knives, needles, and other sharp objects) If there is a large hole in the tent that makes the tent sag obviously, you can use an air pump to quickly add air to avoid collapse. Make sure there is no problem before repairing. (Small holes {within one centimeter} can be repaired with air)

Tent window zipper
If the tent zipper is stuck or cannot be pulled, it is recommended that you pull it back and gently pull it a few times. Try not to pull it hard to avoid damaging the zipper. You can regularly apply some candles on the teeth of the zipper for maintenance.

How to use the active floor cloth
When the tent is inflated and the table is not set, the active floor cloth should be removed in advance to avoid dirt. After the active floor cloth is removed, there will be a circle of sticky tape around the bottom of the tent. Stick a circle of 20 cm wide PVC strips to the air column (there is a 20 cm sticky tape at the bottom of the air column at about a certain distance. You can see it) to avoid walking back and forth and stepping on the sticky tape.

The same is true for the door. After the bottom is removed, cover the other anti-stepping PVC strips we have left.

Prevent firecrackers and other items from being set off at close range. [The distance is preferably 10 meters away, and special attention should be paid to some powerful flammable and explosive items]

Windproof problem of tent: Take precautions in advance. Windproof ropes and ground anchors must be pulled well. Try to pull them up when there is no wind to avoid the instantaneous wind and not having enough time to take precautions.

Folding and loading: When the tent is deflated, open all the windows in advance to prevent the deflation from occurring at the same time as the wind, causing the sticky tape to be misplaced. (Avoid damage to the tent itself in the next use)

How to use the air pump: If it stops during normal inflation, the switch cannot be used. This is because the air pump's own automatic temperature control fuse has been turned on (automatic protection). You only need to wait a few minutes. This is normal. If you use it in direct sunlight in summer, you can use it above the air pump in advance (cover it with a cardboard box or a thinner board to avoid direct heat). The air inlet hole on the air pump must not be blocked.

Send Inquiry
Contact us if have any question

You can either contact us via phone, email or online form below. Our specialist will contact you back shortly.

Contact now!