Inflatable tent use and maintenance
1. The black valve belongs to the rapid inflation port, the gray valve belongs to the multi-function valve (manual pressure reduction, air extraction, air replenishment), and the white valve belongs to the high-pressure explosion-proof valve, also called a pressure reducing valve.
Black bag: Used to quickly inflate the tent. After the inflation is completed, be careful not to twist the black bag cap too hard. If you tighten it hard for a long time, air leakage will occur. Just make sure it is tight and there is no air leakage.
Gray bag: used for air replenishment. If the pressure of the air column is low, you can use the gray bag. When closing the tent, use the gray bag for air extraction.
White pressure reducing valve: When using an inflatable tent in the summer, open the black lid above to prevent the pressure from being too high. Direct sunlight in the summer will cause the air pressure to rise. If the pressure reducing valve exceeds the pressure set by the tent, it will automatically release the pressure.
2. Precautions for tent air pillars: Try not to pull the air pillars hard after opening them. Uneven ground or sharp stones dragging them back and forth will reduce the service life of the tent. Avoid using sharp objects to prick or scratch the air pillars, such as knives, needles, etc. Sharp objects) If there are large holes in the tent that cause the tent to sag significantly, you can use an air pump to quickly refill the air to avoid collapse, and make sure there are no problems before repairing. (Smaller cuts {within one centimeter} can be repaired with breath)
3. Tent window zipper: If the tent zipper is stuck somewhere or cannot be pulled, it is recommended that you pull it back and pull it gently a few times. Try not to pull hard to avoid damage to the zipper. You can regularly apply some candle on the teeth of the zipper for maintenance.
4. How to use the live floor cloth: Before the tent is full of air and the table is set up, the live floor cloth must be removed and stored in advance to avoid getting dirty. After the live floor cloth is removed, there will be a circle of adhesive tape leaking around the bottom of the tent. A circle of 20 cm wide PVC strips is glued to the air column (you can take a look at the 20 cm adhesive strips at about intervals at the bottom of the air column) to avoid walking back and forth and stepping on the adhesive strips.
The same goes for the door. After removing the bottom, cover it with the anti-trampling PVC strips we left.
5. Prevent firecrackers and other items from being set off at close range. [The best distance is 10 meters away. Special attention should be paid to some powerful flammable and explosive items]
6. Tent windproof issues: Take precautionary measures beforehand. Windproof ropes and ground anchors must be pulled up. They should be pulled up as much as possible when there is no wind, so as to avoid the sudden wind and it will be too late to take precautions.
7. Pack up and load the tent: When deflating the tent, open all the windows in advance to prevent the tent from being deflated while being in a joyriding state and causing the adhesive tape to be misaligned. (To avoid damage to the tent itself during next use)
8. How to use the air pump: If there is a stop state during normal inflation, the switch cannot be used. This is because the automatic temperature control insurance of the air pump itself has been turned on (it is an automatic protection). You only need to wait a few minutes. Yes, this is normal. If it is used under direct sunlight in summer, you can use it above the air pump in advance.
(Cover it with a cardboard box or a thinner board to avoid direct heat gain) The air inlet hole on the air pump must not be blocked!
